Toyota Engine

If you can not find the engine you are looking for give us a call. We will make sure you are taken care of.

We Have Performance Engines for the Following Toyota's
3TC - 2JZTGE - 7MGTE - 3SGTE - 2ZZ - 22R - 20R - 4AG
Forged Pistons, Steel Rods, Oversized Stainless Valves, Porting ETC.
Call For Details on what we can do for your project.

CE= Complete Engine as Follows:
(short block as below) assembled with complete cylinder head, and all timing components and oil pump. No oil pan, valve covers, or manifolds

SB= Short Block as Follows:
machined and assembled with over-size pistons, rings, matching crank kit, connecting rods and camshaft (if applicable)

Warranties:
A 12 month or 36,000 mile warranty applies to all parts.
3 Year 100,000 mile Warranties Available.
The original purchaser must make claims for warranty inspection.

Contact RPM for a Repair or Return Authorization Number before proceeding with any warranty work. Have the following information ready when calling: Date of original purchase, Invoice number, RPM part number, a description of the nature of the problem, mile at installation, mileage at failure.

Labor claims cannot exceed $250.00 on a complete engine, $100.00 on a short block. Cylinder head warranties are limited to replacement of head and head set within 90 days of purchase date. No labor claims will be paid on water pumps. Warranties are limited to replacement of the water pump. Hydraulic tensioners are typically sourced from OEM factories, and due to their nature, labor claims on these hydraulic tensioners are limited to replacement only. All other labor claims will be paid at a flat rate of $30 per hour from the Mitchell Flat Rate Manual to a maximum of 10 hours. Credit is issued in the form of a merchandise credit only.

Engine warranties will only be honored if the RPM Installation Checklist is properly filled out, signed by the installer, and returned to RPM within two weeks after the date of installation. Any repair work done without a Repair Authorization Number will void any warranty coverage.

RPM will not be responsible for any damages due to freight, fire, accident, obvious abuse, neglect, or situations where installed used parts cause damage to new parts. The heat tabs must be in place on engines, and not altered or melted.
Parts and engines used for industrial purposes will not be warranted. Bearings, pistons, and rings must be inspected for proper size before installation or warranty is void. No warranty will be honored on heads where heat tabs have been removed, melted or altered. No warranty will be honored on heads where the defect is due to warpage from overheating or the installation of used cams, lifters, or rockers. No warranty will be honored when the cause is found to be oil contamination. It is the responsibility of the installing mechanic to make sure that parts are correct before installation.

RPM does not assume any responsibility for towing charges, fluids, freon, fuel, filters, lay-up time, lodging, car/truck rental or other substitute transportation, telephone charges, travel, damage to personal property, commercial loss, normal diagnostic time, loss of revenue or other matters not specifically included.

Check and replace when needed, the radiator, hoses and belts, fan switch, water and oil pumps, cylinder head bolts, thermostat, fuel mixture, timing and catalytic converter before proceeding with repairs. If you replace your head, pistons, or other parts without determining the actual reason for failure, the new parts will be damaged too!

Don't forget to bookmark this site.